Installtion, Set-up and Use of: Envisalink EVL3 / EVL4, DSC Power Series Alarm systems and Vera UI7 Home Controllers

This directional guide will instruct you on how to physically install the Envisalink EVL3 or EVL4 into an alarm system, setting it up on your network, how to use it, setting up your Vera pertaining to the EVL and optional eyez-on.com account setup.  
Installing an Envisalink EVL to your home alarm system and controlling it with your home controller and or, your mobile device will give you the ability to;

• Control - Arm (Stay or Away), Force Arm, Disarm and Bypass from anywhere. Trigger PGM’s
• Automate - Your alarm system will automatically arm itself when you leave your home and disarm itself when you arrive.
• Monitor - See the status of any zone connected to your alarm system.

This combination of hardware and software is the ultimate in security and convenience.
Oh yea, did I mention there were NO monthly fees?
What You Will Need:

• Alarm system (In the following directions we are using a DSC 1864 system)
• Envisalink EVL (Or similar)
• Vera Controller
• Network Router with DHCP setup on it.
• Computer on the same network as your EVL and Vera for installation and setting up.
• Broadband Internet Access at EVL location.

Here is the instructional paper.