Hi everyone.
I thought I would publish these directions sent to me from Enerwave on how to pair the Enerwave ZWN-RSM2 with SmartThings controller hub. Apparently without this handler SmartThings will not see the relay as a dual relay and thus not work correctly. I do not have a ST controller to test this, so these are the directions quoted from the manufactures email. Here are directions on how to correctly do this.
You can then control the 2 loads separately and get status updates instantly. I hope this helps anyone using a SmartThings controller get their products working correctly. Please direct any questions regarding this setup directly to Enerwave as I do not have a ST device to test or confirm. Thank you.
0 Comments
Your comment will be posted after it is approved.
Leave a Reply. |
Archives
January 2020
Categories
All
|